Back

Instructions for Acqua Bella's L-series canisters

Installation: Fill canister at a rate of 1 to 2 gpm through the outlet port to force trapped air out inlet of vessel. Or, remove the 3/4" bung on the lid and fill the canister in the normal flow direction until water comes out the open bung. Turn off the flow of water and replace the bung. Don't be alarmed if a small amount of carbon comes out of the bung hole at this time. Allow canister to stand 24 hours with inlet bung open to permit de-gassing of carbon bed. Add additional water to completely fill vessel before placing in service. During initial startup, recycle water to remove carbon fines. Do this until water runs clear.

Operation: The granular activated carbon in this vessel will adsorb impurities from the water flow. Removal efficiency is reduced as flow rates are increased. The recommended maximum flow rate is 10 gpm, however some impurities may require less flow to increase carbon contact time. As the carbon becomes saturated, some impurities will begin to pass through. To extend the useful life of the canister it is recommended that two canisters be plumbed in series. Replace the first canister when influent and effluent concentrations in the first canister are equal. Move the second canister to the first position and place the new canister last.

Drain Canister: (Method 1): Using a shop vacuum, hold vacuum hose tight to 2" discharge opening and draw out water. (Method 2): Remove 2" bung from bottom of drum and slice 2 or 3 clean cuts through the liner with a sharp knife. Avoid punching holes in the liner. Several clean slices will allow water to seep out but retain the carbon granules. Allow to drain 24 hours before shipping.

Caution: 1) Do not exceed 12 psig operating pressure. All air must be purged from vessel to prevent storage of energy from the compression of gas 2) Activated carbon has been known to react adversely with some contaminants. Test carbon before if affects are unknown. 3) A Pre-filter for suspended solids should be used to prevent particulate fouling of carbon bed. 4) PH of water may be elevated during startup. Water may require neutralization until effluent meets influent values

Warranty: This product is designed to remove organic impurities from water. Due to the number of hidden variables in water there is no certainty of its capacity. Seller warrants that the product is free from defects. Many of the components in this product have been or may have been recycled. Seller will not be liable for loss or damage to property or any incidental or consequential loss or expense from property damage due directly or indirectly from the use of this product.